Home / ECE / Electronic Devices and Circuits :: Section 14

ECE :: Electronic Devices and Circuits

  1. The effect of a finite gain of operational amplifier used in an integrator is that

  2. A.
    it would not integrator
    B.
    slope of the O/P will varied with time
    C.
    final value of the O/P
    D.
    there will be instability in the cirucuit

  3. The ripple factor from a capacitor filter __________ as the load resistance __________ .

  4. A.
    decreases, decreases
    B.
    decreases, increases
    C.
    increases, decreases
    D.
    increases, increases

  5. Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by

  6. A.
    base collector parasitic capacitor
    B.
    base collector space charge layer capacitance
    C.
    base emitter space charge layer capacitance
    D.
    base emitter diffusion capacitance

  7. Choose proper substitutes for x and y to make the following statement correct.
    Tunnel diode, Avalanche photodiode are operated in x bias and y bias respectively.

  8. A.
    x : Reverse, y : Reverse
    B.
    x : Reverse, y : forward
    C.
    x : Forward, y : Reverse
    D.
    x : forward, y : forward

  9. Assertion (A): When a zener diode breakdown, occurs the voltage across it is constant.

    Reason (R): The upper limit of zener current is determined by power handling capacity.

  10. A.
    Both A and R are true and R is correct explanation of A
    B.
    Both A and R are true but R is not a correct explanation of A
    C.
    A is true but R is false
    D.
    A is false but R is true

  11. Consider the following statements

    1. An iron cored choke is a nonlinear device.
    2. A carbon resistor kept in a sunlight is a time - invariant and passive device.
    3. A dry cell is a time - varying and active device.
    4. An air capacitor is a time - invariant and passive device
    Of these statements

  12. A.
    1, 2, 3 and 4 are correct
    B.
    1, 2 and 3 are correct
    C.
    1, 2 and 4 are correct
    D.
    2 and 4 are correct

  13. If 10 V is the peak voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit), then the maximum voltage on the reverse biased diode will be

  14. A.
    20 V
    B.
    14.14 V
    C.
    10 V
    D.
    7.8 V

  15. In energy band diagram of p type semiconductor the acceptor energy level is

  16. A.
    in valence band
    B.
    in conduction band
    C.
    slightly above valence band
    D.
    slightly below conduction band

  17. Given a power supply filter circuit, what measurements must be made of determine percentage regulation

  18. A.
    current through and voltage across the capacitor
    B.
    d.c. load voltage and r.m.s. load voltage
    C.
    current through load and voltage across load resistance
    D.
    number of turns and gauge of secondary winding of transformer

  19. When the gate terminal of MOSFET is positive, it is said to operate in

  20. A.
    depletion mode
    B.
    conduction mode
    C.
    enhancement mode
    D.
    none of the above