Home / ECE / Analog Electronics :: Section 17

ECE :: Analog Electronics

  1. In the case of the circuit shown in the figure, the collector current IC will be, if β = 100, VBE = 0.7 V, ICO = 0.1 βA at 20°C

  2. A.
    2.26 mA
    B.
    1.85 mA
    C.
    0.357 mA
    D.
    0.185 mA

  3. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is

  4. A.
    1.1 kHz
    B.
    2.5 kHz
    C.
    3.3 kHz
    D.
    6.5 kHz

  5. The circuit of figure is

  6. A.
    positive clipper
    B.
    negative clipper
    C.
    combination clipper
    D.
    either (a) or (b)

  7. Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

    Reason (R): Hartley oscillator uses a tapped inductor

  8. A.
    Both A and R are correct and R is correct explanation for A
    B.
    Both A and R are correct but R is not correct explanation for A
    C.
    A is correct R is wrong
    D.
    A is wrong R is correct

  9. In figure VCE (sat) = 0.1 V. Then IC (sat) =

  10. A.
    10 mA
    B.
    20 mA
    C.
    30 mA
    D.
    40 mA

  11. Power transistors are invariably provided with

  12. A.
    soldered connections
    B.
    heat sink
    C.
    metallic casing
    D.
    none of the above

  13. Assertion (A): The ac load line is different from dc load line

    Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

  14. A.
    Both A and R are correct and R is correct explanation for A
    B.
    Both A and R are correct but R is not correct explanation for A
    C.
    A is correct R is wrong
    D.
    A is wrong R is correct

  15. In a class C operation VCC = 40 V and VCE(sat) = 0.4 V. The efficiency is

  16. A.
    90%
    B.
    49.5%
    C.
    1%
    D.
    0.5%

  17. The circuit shown in figure will

  18. A.
    oscillate at 456 kHz
    B.
    oscillate at 228 kHz
    C.
    oscillate at microwave frequency
    D.
    not oscillate

  19. The absolute values of pinch-off voltage and gate-source cut-off voltage are

  20. A.
    nearly zero
    B.
    complementary to each other
    C.
    never equal
    D.
    equal