Home / ECE / Analog Electronics :: Section 20

ECE :: Analog Electronics

  1. Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?

  2. A.
    Differentiating amplifier
    B.
    Integrating amplifier
    C.
    Logarithmic amplifier
    D.
    Exponential amplifier

  3. Saturation of iron core causes distortion.

  4. A.
    True
    B.
    False

  5. Which of the following is non-sinusoidal oscillator?

  6. A.
    Multivibrator
    B.
    Relaxation oscillator using UJT
    C.
    Relaxation oscillator using tunnel diode
    D.
    Any of the above

  7. Low gain-bandwidth product of a JFET is due to

  8. A.
    reduced number of holes
    B.
    junction capacitive effects
    C.
    low degree of isolation between input and output
    D.
    all of the above

  9. The circuit of the figure is an example of feedback of the following type

  10. A.
    current series
    B.
    current shunt
    C.
    voltage series
    D.
    voltage shunt

  11. Oscillation frequency in Wein bridge oscillator is

  12. A.
    B.
    C.
    f = 2p CR
    D.

  13. Assertion (A): A class C amplifier can also be used as frequency multiplier

    Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave

  14. A.
    Both A and R are correct and R is correct explanation for A
    B.
    Both A and R are correct but R is not correct explanation for A
    C.
    A is correct R is wrong
    D.
    A is wrong R is correct

  15. The parameter β of a BJT change by 300%. If self bias is used in the amplifier using this BJT, the quiescent value of IC and VCE remain almost the same.

  16. A.
    True
    B.
    False

  17. A bypass capacitor produces

  18. A.
    dc ground
    B.
    ac ground
    C.
    both dc and ac ground
    D.
    none of the above

  19. Rise time in a transistor is change from

  20. A.
    10% of its final value to 90% of its final value
    B.
    0% of its final value to 90% of its final value
    C.
    10% of its final value to 100% of its final value
    D.
    10% to its final value to 50% of its final value