Home / ECE / Analog Electronics :: Section 10

ECE :: Analog Electronics

  1. A Darlington circuit is obtained by connecting

  2. A.
    two CB stages in cascade
    B.
    two CE stages in cascade
    C.
    a CE stages followed by CB stage
    D.
    two emitter follower in cascade

  3. A CE amplifier has a high input signal. In the wave shape of emitter current

  4. A.
    positive and negative half cycles will be symmetrical
    B.
    positive half cycle will be elongated and negative half cycle will be compressed
    C.
    positive half cycle will be compressed and negative half cycle will be elongated
    D.
    the half cycles may be either elongated or compressed

  5. An inverting voltage feedback is a

  6. A.
    voltage amplifier
    B.
    current amplifier
    C.
    current to voltage converter
    D.
    voltage to current converter

  7. If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the

  8. A.
    forward active mode
    B.
    reverse saturation mode
    C.
    reverse active mode
    D.
    forward saturation mode

  9. In a CE amplifier the Q point is very close to cutoff point on the load line. This results in

  10. A.
    saturation clipping
    B.
    cut off clipping
    C.
    both saturation and cut off clipping
    D.
    either saturation clipping or cut off clipping

  11. If the value of C2 and C3 are doubled, the oscillation frequency will be

  12. A.
    quadrupled
    B.
    doubled
    C.
    unchanged
    D.
    halved

  13. Which of the following statement about JFET is correct?

  14. A.
    In an N-channel JFET, the channel is the narrowest under zero gate bias condition
    B.
    In a JFET the gates are always forward biased
    C.
    In a JFET, gate-source cut off voltage is numerically equal to the pinch off voltage
    D.
    It is a voltage controlled device

  15. Assertion (A): In Darlington pair, the overall β is product of individual βs

    Reason (R): The voltage gain of a base driven amplifier is equal to ac collector voltage divided by ac base voltage

  16. A.
    Both A and R are correct and R is correct explanation for A
    B.
    Both A and R are correct but R is not correct explanation for A
    C.
    A is correct R is wrong
    D.
    A is wrong R is correct

  17. A Wien bridge oscillator uses Wien bridge for

  18. A.
    tuning and phase shift
    B.
    tuning
    C.
    phase shift
    D.
    either tuning or phase shift

  19. A cascade amplifier will have higher cut off frequency

  20. A.
    equal to that of single stage amplifier
    B.
    less than that of single stage amplifier
    C.
    more than that of single stage amplifier
    D.
    none of these