Home / ECE / Analog Electronics :: Section 10

ECE :: Analog Electronics

  1. When narrow current pulses drive a high Q resonant circuit the voltage across the circuit looks like

  2. A.
    narrow pulses
    B.
    half sine wave
    C.
    almost sine wave
    D.
    either (a) or (b)

  3. The multivibrator circuit that has a typical application of converting sinusoidal input into a square wave output is

  4. A.
    emitter coupled binary
    B.
    Schmitt trigger
    C.
    monoshot multivibrator
    D.
    free-running multivibrator

  5. Symbol shown in figure represents a

  6. A.
    P-channel enhancement MOSFET
    B.
    N-channel DEMOSFET
    C.
    UJT with P-type base
    D.
    UJT with N-type base

  7. The feedback resistance rd in small signal model of MOSFET is of the order of

  8. A.
    1000 MΩ
    B.
    1 MΩ
    C.
    1 KΩ
    D.
    100 Ω

  9. Which amplifier has a voltage gain of less than 1?

  10. A.
    Common emitter
    B.
    Common collector
    C.
    Common base
    D.
    Both CB and CC

  11. A clamper

  12. A.
    adds a dc component to the input signal
    B.
    removes signal voltages above or below a specified value
    C.
    both (a) and (b)
    D.
    either (a) or (b)

  13. For holding the drain current constant in spite of large changes in JFET parameters

  14. A.
    current source bias is used
    B.
    voltage divider bias is used
    C.
    reverse bias is used
    D.
    no bias is used

  15. The main disadvantage of a JFET is

  16. A.
    low gain-bandwidth product
    B.
    high noise level
    C.
    high cost
    D.
    low gain

  17. For Q >> 1, the output frequency of LC oscillator is equal to resonant frequency.

  18. A.
    True
    B.
    False

  19. At the peak of negative half cycle in figure

  20. A.
    diode A is forward biased and diode B is reverse biased
    B.
    both diodes are reverse biased
    C.
    both diodes are forward biased
    D.
    diode A is reverse biased and diode B is forward biased