Home / ECE / Analog Electronics :: Section 4

ECE :: Analog Electronics

  1. An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are

  2. A.
    10 Ω and 1 Ω
    B.
    10 Ω and 10 kΩ
    C.
    100 kΩ and 1 Ω
    D.
    100 kΩ and 10 Ω

  3. In a BJT amplifier the power gain from base to collector is 4000. The power gain in dB is

  4. A.
    3.6
    B.
    36
    C.
    7.2
    D.
    72

  5. In figure, secondary winding has 40 turns. For maximum power transformer to 2 ohm resistance the number of turns in primary is

  6. A.
    20
    B.
    40
    C.
    80
    D.
    160

  7. In a CE amplifier circuit the dc voltage between emitter and ground

  8. A.
    is always zero
    B.
    cannot be zero
    C.
    may or may not be zero
    D.
    is negative

  9. A buffer amplifier should have

  10. A.
    high output impedance and high input impedance
    B.
    high output impedance and low input impedance
    C.
    low output impedance an low input impedance
    D.
    low output impedance and high input impedance

  11. If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is

  12. A.
    23 dB
    B.
    25 dB
    C.
    46 dB
    D.
    50 dB

  13. An npn transistor has a Beta cutoff frequency fβ of 1 MHz, and a common emitter short circuit low frequency current gain β0 of 200. It unity gain frequency fT and the alpha cut off frequency fa2 respectively are

  14. A.
    200 MHz, 201 MHz
    B.
    200 MHz, 199 MHz
    C.
    199 MHz, 200 MHz
    D.
    201 MHz, 200 MHz

  15. In figure if the transistor is cut off, the collector voltage is equal to

  16. A.
    VCC
    B.
    0.5 VCC
    C.
    D.
    zero

  17. If input frequency is 50 Hz, the frequency of output wave in a full wave diode rectifier circuit is

  18. A.
    25 Hz
    B.
    50 Hz
    C.
    100 Hz
    D.
    200 Hz

  19. A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than

  20. A.
    5 W
    B.
    10 W
    C.
    20 W
    D.
    40 W