Home / ECE / Network Analysis and Synthesis :: Section 8

ECE :: Network Analysis and Synthesis

  1. The admittance parameter Y12 in the 2 port network in the figure

  2. A.
    -0.2 mho
    B.
    0.1 mho
    C.
    -0.05 mho
    D.
    0.05 mho

  3. The differential equation for the current i(t) in the Ckt is


  4. A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through

  5. A.
    inductor
    B.
    capacitor
    C.
    resistor
    D.
    all

  6. A series resonant circuit has parameters 10 ω, 1 H and 0.1 F. It is excited by a voltage v = 100 sin ωt. At resonant frequency, the power dissipated in the circuit is

  7. A.
    1000 W
    B.
    707 W
    C.
    500 W
    D.
    414.14 W

  8. Assertion (A): A tree of graph contains all the nodes of the graph.

    Reason (R): The number of links is always less than the number of tree branches.

  9. A.
    Both A and R are true and R is correct explanation of A
    B.
    Both A and R are true and R is not the correct explanation of A
    C.
    A is true but R is false
    D.
    A is false but R is true

  10. Cells are connected in series to increase

  11. A.
    current-rating
    B.
    both voltage and current rating
    C.
    the life of cell
    D.
    voltage rating

  12. The low pass filter characteristic shown in figure realizable.

  13. A.
    True
    B.
    False

  14. Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

    Reason (R): Complex frequency s = σ + jω.

  15. A.
    Both A and R are true and R is correct explanation of A
    B.
    Both A and R are true and R is not the correct explanation of A
    C.
    A is true but R is false
    D.
    A is false but R is true

  16. If Va = 10 ∠0, Vb = 10 ∠ -120° and Vc = 10 ∠ -240°, then Va2 and Va0 are

  17. A.
    10 and 0 respectively
    B.
    0 and 10 respectively
    C.
    0 and 0
    D.
    10 and 10

  18. A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be

  19. A.
    R/3
    B.
    3 R
    C.
    R/9
    D.
    9 R