Home / ECE / Network Analysis and Synthesis :: Section 4

ECE :: Network Analysis and Synthesis

  1. For an RLC series circuit, Z(s) will be of the form of


  2. In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2 C is

  3. A.
    zero
    B.
    1 A
    C.
    2 A
    D.
    3 A

  4. As temperature increases, the temperature coefficient of a metal

  5. A.
    decreases
    B.
    increases
    C.
    remains unchanged
    D.
    any of the above

  6. A wire has a resistance R ohm. If another wire of the same material and same weight has double the diameter (as compared to the first wire), the resistance of the second wire will be

  7. A.
    0.5 R
    B.
    0.25 R
    C.
    0.125 R
    D.
    R/16

  8. Volt is equivalent to

  9. A.
    joule/coulomb
    B.
    joule/watt
    C.
    joule/ampere
    D.
    joule/volt

  10. A two branch parallel tuned circuit has a capacitance C in one of the two branches and resistance R in second branchs. As C is decreased the dynamic resistance

  11. A.
    increases
    B.
    decreases
    C.
    remains constant
    D.
    may increases or decreases

  12. A system function the resonant frequency in rad/sec and bandwidth in rad/sec is given by

  13. A.
    5, 10
    B.
    5, 4
    C.
    10, 4
    D.
    10, 10

  14. The reading of the voltmeter in figure will be __________ volt.

  15. A.
    100
    B.
    150
    C.
    zero
    D.
    200

  16. Find RL for maximum power transfer

  17. A.
    3 Ω
    B.
    1.125 Ω
    C.
    4.17 Ω
    D.
    none

  18. In an R-C circuit, the impedance is 40 Ω at a frequency of 100 Hz. At 200 Hz the impedance should be

  19. A.
    40 Ω
    B.
    80 Ω
    C.
    20 Ω
    D.
    more than 20 Ω but less than 40 Ω