Home / ECE / Exam Questions Paper :: Section 18

ECE :: Exam Questions Paper

  1. Which of the following devices is used in the microprocessors?

  2. A.
    JFET
    B.
    BJT
    C.
    MOSFET
    D.
    CMOS

  3. A 2 bit binary multiplier can be implemented using

  4. A.
    2 inputs ANDs only
    B.
    2 inputs XORs and 4 input AND gates only
    C.
    Two 2 inputs NORs and one XNOR gate
    D.
    XOR gates and shift registers

  5. Which one of the following circuits is used for converting a sine wave into a square wave?

  6. A.
    Astable multivibration
    B.
    Monostable multivibration
    C.
    Bistable multivibration
    D.
    Schmitt trigger

  7. A super heterodyne receiver has a IF of 465 kHz. It is tuned to a station broadcasting at 500 KHz and its oscillator is operating at 965 KHz, then the 1330 KHz frequency would be

  8. A.
    adjacent channel frequency
    B.
    image frequency
    C.
    gyro frequency
    D.
    maximum usable frequency

  9. Following are the properties of impulse function

    1. x(t) ∂(t) = x (0)∂(t)
    2. ∂(- t) = ∂(t)
    Choose the correct option

  10. A.
    1-true, 2-false, 3-true
    B.
    1-false, 2-true, 3-true
    C.
    1-true, 2-true, 3-true
    D.
    1-true, 2-true, 3-false

  11. What is an advantage of an electronic voltmeter over a non-electronic voltmeter?

  12. A.
    Low power consumption
    B.
    Low input impedance
    C.
    The ability to measure wide ranges of voltages and resistance
    D.
    Large portability

  13. Which of the following statements is/are true for the diamond structure?

    1. Coordination number is four.
    2. Packing fraction is 0.34
    3. Copper crystallizes into diamond structure
    4. Lattice is FCC.

  14. A.
    1 only
    B.
    1, 2 and 4
    C.
    2 and 3 only
    D.
    2, 3 and 4

  15. Assertion (A): There are no convergence issues with the discrete-time Fourier series in general.

    Reason (R): A discrete-time signal is always obtained by sampling a continuous-time signal.

  16. A.
    Both A and R are individually true and R is the correct explanation of A
    B.
    Both A and R are individually true but R is not the correct explanation of A
    C.
    A is true but R is false
    D.
    A is false but R is true

  17. Which is the dominant mode in rectangular waveguides?

  18. A.
    TE10
    B.
    TE11
    C.
    TE01
    D.
    TM11

  19. Which of the following are the memory performance parameters?

    1. Access time and latency
    2. Block size and Block access time
    3. Cycle time and Bandwidth
    Select the correct answer from the codes given below:

  20. A.
    1 only
    B.
    1 and 2 only
    C.
    2 and 3 only
    D.
    1, 2 and 3