Home / Civil Engineering / UPSC Civil Service Exam Questions :: Section 14

Civil Engineering :: UPSC Civil Service Exam Questions

  1. Bricks are burnt at a temperature range of

  2. A.
    500° to 700°C
    B.
    700° to 900°C
    C.
    900° to 1200°C
    D.
    1200° to 1500°C

  3. Drop panel is a structural component in :

  4. A.
    grid floor
    B.
    flat plate
    C.
    flat slab
    D.
    slab-beam system of floor

  5. A ship is berthed in a chamber and lifted by principles of buoyancy. Such a chmber is called

  6. A.
    Dry dock
    B.
    Web dock
    C.
    Floating dock
    D.
    Refuge dock

  7. Which one of the following pairs is not correctly matched ?

  8. A.
    Check valve - To check water flow in all directions
    B.
    Sluice valve - To control flow of water through pipe lines
    C.
    Air valve - To release the accumulated air
    D.
    Scour valve - To remove silt in a pipe line

  9. The following refer to the stability analysis of an earth dam under different conditions :
    1. Stability of D/S slope during steady seepage.
    2. Stability of U/S slope during sudden drawdown.
    3. Stability of U/S and D/S slopes during construction.
    Of these statements :

  10. A.
    1 and 2 are correct
    B.
    1 and 3 are correct
    C.
    2 and 3 are correct
    D.
    1, 2 and 3 are correct

  11. A bar AB, 4 cm is diameter and 4 m long is rigidly fixed at its ends. A torque of 12000 kg/cm is applied at a section of the bar, one metre from end A. The fixing coupled TA and TB (in kg. cm) at the supports A and B will be respectively

  12. A.
    9000, 6000
    B.
    3000, 9000
    C.
    6000, 9000
    D.
    9000, 3000

  13. Consider the following assumptions of Bowditch method :
    1. Angular measurements are more precise than linear measurements.
    2. Linear measurements are more prescise than angular measurements.
    3. Erros in linear measurements are proportional to L.
    4. Correction to latitude or departure of any side = Total error in L (or D) x Length of that side / Perimeter of traverse.
    Which of these statements are correct ?

  14. A.
    1 and 4
    B.
    1, 2 and 3
    C.
    2, 3 and 4
    D.
    3 and 4

  15. For the beam shown in the given figure, the collapse load P is given by


  16. For a laminated spring, l = length, n = number of plates, width of each plate = b, thickness of each plate = t, central point load = W, what is the expression for the maximum bending stores ?

  17. A.
    * 2
    B.
    C.
    D.

  18. Two particles of masses 21 gm and 28 gm are connected by a light inextensible string which passes over a fixed smooth pulley. The tension in the string in the ensuing motion will be

  19. A.
    7 gm. wt
    B.
    10 gm. wt
    C.
    12 gm. wt
    D.
    24 gm. wt