Home / Chemical Engineering / Stoichiometry :: Section 5

Chemical Engineering :: Stoichiometry

  1. On mixing 56 gm of CaO with 63 gm of HNO3, the amount of Ca(NO3)2 formed is __________ gm.

  2. A.
    82
    B.
    164
    C.
    41
    D.
    8.2

  3. The pressure under which liquid and vapor can co-exit at equilibrium is called the __________ vapor pressure.

  4. A.
    limiting
    B.
    real
    C.
    saturated
    D.
    normal

  5. Unrestrained expansion of an ideal gas does not result in its cooling due to the reason that the gas molecules

  6. A.
    do not lose energy on collision.
    B.
    are above the inversion temperature.
    C.
    do not exert attractive force on each other.
    D.
    do work equal to loss in kinetic energy.

  7. Assuming applicability of ideal gas law, the pure component volume of the vapor in a saturated gas can be calculated from theoretical relationship. The volumetric composition of a vapor saturated gas is independent of the

  8. A.
    nature of the liquid.
    B.
    nature of the gas.
    C.
    temperature of the liquid. id) total pressure.

  9. Air at a temperature of 20°C and 750 mm Hg pressure has a relative humidity of 80%. What is its percentage humidity ? Vapour pressure of water at 20°C is 17.5 mm Hg.

  10. A.
    80.38
    B.
    80
    C.
    79.62
    D.
    78.51

  11. One mole of methane undergoes complete combustion in a stoichiometric amount of air. The reaction proceeds as CH4 + 2O2 → CO2 + 2H2O. Both the reactants and products are in gas phase. ΔH°298 = - 730 kJ/mole of methane. If the average specific heat of all the gases/vapour is 40 J/mole.K, the maximum temperature rise of the exhaust gases in °C would be approximately equal to

  12. A.
    1225
    B.
    1335
    C.
    1525
    D.
    1735

  13. As per Kirchoff s equation, the heat of reaction is affected by the

  14. A.
    pressure
    B.
    volume
    C.
    temperature
    D.
    molecularity

  15. In a chemical process, the recycle stream is purged for

  16. A.
    increasing the product yield.
    B.
    enriching the product.
    C.
    limiting the inerts.
    D.
    heat conservation.

  17. The viscosity of water at room temperature may be around one

  18. A.
    centipoise
    B.
    poise
    C.
    stoke
    D.
    both (b) &(c)

  19. A flowsheet is given in the following figure:

    If the single pass once through conversion of A to B is 20%, then the rate of recycle R (molds/hr) is

  20. A.
    300
    B.
    400
    C.
    500
    D.
    600