Mechanical Engineering :: Production Engineering
-
The angle between the face and flank of the single point cutting tool is known as
-
In order to obtain a surface finish in the range of 0.75 μm to 1.25 μm , the operation used is called.
-
Which of the following statement is correct as regard to up milling?
-
In determining the various forces on the chip, Merchant assumed that the
-
Hard and tough materials like cast iron should be turned at
-
In oblique cutting system, the cutting edge of the tool
-
When the shear angle is small
-
A fine grained grinding wheel is used to grind
-
EDM machining is applied for
Whatsapp
Facebook
|
A.
It can not be used on old machines due to backlash between the feed screw of the table and the nut.
|
|
B.
The chips are disposed off easily and do not interfere with the cutting.
|
|
C.
The surface milled appears to be slightly wavy.
|
|
D.
The coolant can be poured directly at the cutting zone where the cutting force is maximum.
|