Home / ECE / Microwave Communication :: Section 6

ECE :: Microwave Communication

  1. TE01 mode of propagation of electromagnetic energy

  2. A.
    is merely the TE10 mode rotated 90°
    B.
    is merely the TE10 mode rotated 180°
    C.
    is the same as TE10 mode
    D.
    either (b) or (c)

  3. Assertion (A): Slotted line is frequently used for microwave measurements.

    Reason (R): The unknown impedance is mounted at the end of slotted line.

  4. A.
    Both A and R are correct and R is correct explanation of A
    B.
    Both A and R are correct but R is not correct explanation of A
    C.
    A is correct but R is wrong
    D.
    A is wrong but R is correct

  5. Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have

  6. A.
    reduced losses
    B.
    high bandwidth
    C.
    reduced losses and low bandwidth
    D.
    more losses and low bandwidth

  7. The following components are used to measure power output of a 2 kW TWT amplifier

    1. TWT
    2. Low pass/High pass filter
    3. Low power 20 dB attenuator
    4. 40 dB directional coupler with matched load
    5. Power meter.
    The correct sequence of connections of these components is:

  8. A.
    1, 4, 2, 3, 5
    B.
    1, 3, 4, 2, 5
    C.
    1, 2, 4, 3, 5
    D.
    1, 4, 3, 2, 5

  9. Which part of radio spectrum is more crowded?

  10. A.
    Lower frequency part
    B.
    Higher frequency part
    C.
    Both (a) and (b)
    D.
    None of these

  11. As compared to their values in free space

  12. A.
    velocity of electric wave in dielectric is smaller but wave length of electric wave is more
    B.
    both velocity and wave length of electric wave in dielectric are higher
    C.
    both velocity and wave length of electric wave in dielectric are smaller
    D.
    wave length of electric wave is less but velocity is more in dielectric

  13. A 3 port circulator is in the given figure. Its scattering matrix is


  14. Characteristic impedance of a coaxial cable is inversely proportional to r.

  15. A.
    True
    B.
    False

  16. A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by

  17. A.
    a shunt capacitance at the discontinuity
    B.
    a shunt inductance at the discontinuity
    C.
    a shunt resistance at the discontinuity
    D.
    none of the above

  18. Depth of penetration does not depend on frequency.

  19. A.
    True
    B.
    False