Home / ECE / Communication Systems :: Section 25

ECE :: Communication Systems

  1. Which of the following is an indirect way of generating FM?

  2. A.
    Armstrong modulator
    B.
    Varactor diode modulator
    C.
    Reactance FET modulator
    D.
    Reactance bipolar transistor

  3. When the length of antenna is a whole wavelength

  4. A.
    the radiation at right angles is zero
    B.
    the radiation at right angles is maximum
    C.
    the radiation is zero in all directions
    D.
    the radiation is maximum in all directions

  5. Circular polarization

  6. A.
    is useful in reducing depolarization effect on received wave
    B.
    involves critical alignment of transmitting and receiving antenna
    C.
    is useful in discrimination between reception of adjacent beams
    D.
    none of the above

  7. An FM radio receiver which is tuned to a 91.6 MHz broadcast station may receive an image frequency of __________ MHz.

  8. A.
    102.3
    B.
    113
    C.
    70.2
    D.
    80.9

  9. If S represents the carrier synchronization at the receiver and r represents the bandwidth efficiency, then the correct statement for the coherent binary PSK is

  10. A.
    r = 0.5, S is required
    B.
    r = 1.0, S is required
    C.
    r = 0.5, S is not required
    D.
    r = 1.0, S is not required

  11. For telegraphy the most commonly used modulation system is

  12. A.
    FSK
    B.
    two tone modulation
    C.
    PCM
    D.
    single tone modulation

  13. Commercial Frequency deviation of FM is

  14. A.
    70 kHz
    B.
    75 kHz
    C.
    80 kHz
    D.
    65 kHz

  15. The colour of an object is decided by

  16. A.
    the reflected colour
    B.
    the wavelength transmitted through it
    C.
    reflected colour for opaque object and wavelength transmitted through it for transparent objects
    D.
    none of the above

  17. In Pulse Code Modulation system

  18. A.
    large bandwidth is required
    B.
    quantising noise can be overcome by companding
    C.
    quantising noise can be reduced by decreasing the number of standard levels
    D.
    suffers from the disadvantage of its incompatibly with TDM

  19. Waveform shown in figure is that for

  20. A.
    FM
    B.
    PCM
    C.
    AM-DSB
    D.
    AM-SSB