Home / ECE / Communication Systems :: Section 18

ECE :: Communication Systems

  1. Some features of RF stage in good radio receivers is

    1. It increases sensitivity by providing amplification to RF signal
    2. It eliminates image frequency interference
    3. It increases selectivity
    4. It reduces noise level
    Which of the above are true?

  2. A.
    1, 2 and 3 only
    B.
    1, 2 and 4 only
    C.
    2, 3, 4 only
    D.
    1, 2, 3, 4

  3. During amplitude modulation, the phase angle of the modulating voltage changes by

  4. A.
    B.
    45°
    C.
    90°
    D.
    180°

  5. The image frequency of a superheterodyne receiver is

  6. A.
    created within the receiver itself
    B.
    not rejected by IF tuned circuits
    C.
    independent of the frequency of tuning
    D.
    due to insufficient adjacent channel rejection

  7. Image frequency rejection mainly depends upon

  8. A.
    detector
    B.
    mixer
    C.
    IF
    D.
    RF

  9. Which of the following is most likely to be found in an SSB transmitter?

  10. A.
    Class A, RF output amplifier
    B.
    Class B, RF amplifier
    C.
    Tuned modulator
    D.
    Class C, audio amplifier

  11. Which of the following statement is correct?

  12. A.
    Pre-emphasis circuits are used in AM transmitters
    B.
    FM reception is noise free as compared to AM
    C.
    A limiter state is also used in AM receivers
    D.
    Discriminator is used for the detection of AM signals

  13. Which of the following is true as regards telephone systems?

  14. A.
    A larger facility carrying a larger load operates less efficiently than a smaller capacity
    B.
    A larger facility carrying a lesser load operates more efficiently than a smaller capacity
    C.
    A larger facility carrying a larger load operates more efficiently than a smaller capacity
    D.
    A smaller capacity carrying a larger load operates more efficiently than a larger capacity

  15. SSB can be generated by

  16. A.
    filter method
    B.
    phase shift method
    C.
    weaver's method
    D.
    none of the above

  17. Which one of the following cannot be used to remove the unwanted sideband in SSB?

  18. A.
    Balanced modulator
    B.
    Phase shift method
    C.
    Filter system
    D.
    Third method

  19. For FM, which of the following statement is not true?

  20. A.
    The bandwidth increases as modulation index is increased
    B.
    The total power remains constant with respect to modulation index
    C.
    The carrier never becomes zero
    D.
    All of the above