Computer Science :: Computer Networking
-
Which of the following statements are true regarding the command ip route 172.16.4.0 255.255.255.0 192.168.4.2?
1. The command is used to establish a static route.
2. The default administrative distance is used.
3. The command is used to configure the default route.
4. The subnet mask for the source address is 255.255.255.0.
- Which command displays RIP routing updates?
-
Which statement is true regarding classless routing protocols?
1. The use of discontiguous networks is not allowed.
2. The use of variable length subnet masks is permitted.
3. RIPv1 is a classless routing protocol.
4. IGRP supports classless routing within the same autonomous system.
5. RIPv2 supports classless routing. -
You have the following routing table. Which of the following networks will not be placed in the neighbor routing table?
R 192.168.30.0/24 [120/1] via 192.168.40.1, 00:00:12, Serial0
C 192.168.40.0/24 is directly connected, Serial0
172.16.0.0/24 is subnetted, 1 subnets
C 172.16.30.0 is directly connected, Loopback0
R 192.168.20.0/24 [120/1] via 192.168.40.1, 00:00:12, Serial0
R 10.0.0.0/8 [120/15] via 192.168.40.1, 00:00:07, Serial0
C 192.168.50.0/24 is directly connected, Ethernet0
- What is split horizon?
- What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
- Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
- You type debug ip rip on your router console and see that 172.16.10.0 is being advertised to you with a metric of 16. What does this mean?
-
The Corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output from the Corporate router, what will the router do with this packet?
Corp#sh ip route
[output cut]
R 192.168.215.0 [120/2] via 192.168.20.2, 00:00:23, Serial0/0
R 192.168.115.0 [120/1] via 192.168.20.2, 00:00:23, Serial0/0
R 192.168.30.0 [120/1] via 192.168.20.2, 00:00:23, Serial0/0
C 192.168.20.0 is directly connected, Serial0/0
C 192.168.214.0 is directly connected, FastEthernet0/0
- If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?
Whatsapp
Facebook
|
A.
Information about a route should not be sent back in the direction from which the original update came. |
|
B.
It splits the traffic when you have a large bus (horizon) physical network. |
|
C.
It holds the regular updates from broadcasting to a downed link. |
|
D.
It prevents regular update messages from reinstating a route that has gone down. |
|
A.
The updated information will be added to the existing routing table. |
|
B.
The update will be ignored and no further action will occur. |
|
C.
The updated information will replace the existing routing table entry. |
|
D.
The existing routing table entry will be deleted from the routing table and all routers will exchange routing updates to reach convergence. |
|
E.
They will all load-balance. |