Home / Chemical Engineering / Mass Transfer :: Section 3

Chemical Engineering :: Mass Transfer

  1. Percentage saturation is __________ the relative saturation.

  2. A.
    always smaller than
    B.
    always greater than
    C.
    not related to
    D.
    none of these

  3. In case of a desorber (stripper), the

  4. A.
    operating line always lies above the equilibrium curve.
    B.
    operating line always lies below the equilibrium curve.
    C.
    temperature remains unaffected.
    D.
    temperature always increases.

  5. What is the reflux ratio at total reflux ?

  6. A.
    Zero
    B.
    Infinity
    C.
    Unity
    D.
    Data insufficient

  7. Under conditions of flooding in packed tower, the gas pressure drop

  8. A.
    decreases rapidly
    B.
    increases rapidly
    C.
    remains constant
    D.
    is maximum

  9. For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of __________ microns (1 mm = 1000 microns).

  10. A.
    1-5
    B.
    10-60
    C.
    200-300
    D.
    > 500

  11. For absorbing a sparingly soluble gas in a liquid

  12. A.
    gas side mass transfer co-efficient should be increased.
    B.
    liquid side mass transfer co-efficient should be increased.
    C.
    liquid side mass transfer co-efficient should be decreased.
    D.
    mass transfer co-efficient must be kept constant.

  13. Channelling in a packed tower results from the

  14. A.
    high pressure drop
    B.
    maldistribution of liquid
    C.
    non-uniformity of packing
    D.
    both (b) and (c)

  15. The change in enthalpy per unit weight of adsorbed gas when adsorbed on gas free or "outgassed" adsorbent to from a definite concentration of adsorbate is called its

  16. A.
    integral heat of adsorption.
    B.
    heat of wetting.
    C.
    differential heat of adsorption.
    D.
    heat of normal condensation.

  17. The minimum number of theoretical plates is required for achieving a given separation in distillation column with

  18. A.
    no reflux
    B.
    total reflux
    C.
    zero reflux ratio
    D.
    minimum reflux ratio

  19. A good solvent used for absorption should not have very high

  20. A.
    viscosity
    B.
    vapor pressure
    C.
    freezing point
    D.
    all (a), (b) & (c)