Menu
Home / Mechanical Engineering / Workshop Technology :: section-8

Mechanical Engineering :: Workshop Technology

Workshop Technology - Section 1
Workshop Technology - Section 2
Workshop Technology - Section 3
Workshop Technology - Section 4
Workshop Technology - Section 5
Workshop Technology - Section 6
Workshop Technology - section-7
Workshop Technology - section-8
  1. In a cold chamber die casting machine

    2. A.

     Melting pot is separate from the machine
    B.

     Melting pot is an integral part of the machine
    C.

     Melting pot may have any location
    D.

     Low temperature and pressure is used

    View Answer

    Workspace

    Discuss Discuss in Forum

  2. Carburising flame is used to weld

    3. A.

     Steel, cast iron, copper, aluminium etc
    B.

     Brass and bronze
    C.

     Hard surfacing materials such as stellite
    D.

     All of these

    View Answer

    Workspace

    Discuss Discuss in Forum

  3. A progressive limit gauge has

    4. A.

     'Go' and 'Not go' member on the same side of the gauge
    B.

     Separate 'Go' and 'Not go' members
    C.

     'Go' member at one end and 'Not go' member at the other end
    D.

     None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum

  4. The temperature at which the new grains are formed in the metal is called

    5. A.

     Lower critical temperature
    B.

     Upper critical temperature
    C.

     Eutectic temperature
    D.

     Recrystallisation temperature

    View Answer

    Workspace

    Discuss Discuss in Forum

  5. The purpose of a gate is to

    6. A.

     Delivers molten metal into the mould cavity
    B.

     Act as a reservoir for the molten metal
    C.

     Feed the molten metal to the casting in order to compensate for the shrinkage
    D.

     Delivers molten metal from pouring basin to gate

    View Answer

    Workspace

    Discuss Discuss in Forum

  6. In order to check the clearance between two mating surfaces, a ________ gauge should be used.

    7. A.

     Ring
    B.

     Plug
    C.

     Feeler
    D.

     None of these

    View Answer

    Workspace

    Discuss Discuss in Forum

  7. In forehand welding, the angle between the welding rod and the work is kept as

    8. A.

     30°-40°
    B.

     40°-50°
    C.

     50°-60°
    D.

     60°-70°

    View Answer

    Workspace

    Discuss Discuss in Forum

  8. In backhand welding, the angle between the welding torch and the work is kept as

    9. A.

     30°-40°
    B.

     40°-50°
    C.

     50°-60°
    D.

     60°-70°

    View Answer

    Workspace

    Discuss Discuss in Forum

  9. In electric resistance welding, voltage required for heating is

    10. A.

     1 to 5 volts
    B.

     6 to 10 volts
    C.

     11 to 20 volts
    D.

     50 to 100 volts

    View Answer

    Workspace

    Discuss Discuss in Forum

  10. To prevent the body of the blade from jamming in the saw cut, the teeth of blade are

    11. A.

     Strengthened
    B.

     Sharpened
    C.

     Set
    D.

     All of these

    View Answer

    Workspace

    Discuss Discuss in Forum

Java Programming Questions and Answers Interview Questions and Answers