Home / ECE / Electromagnetic Field Thoery :: Section 1

ECE :: Electromagnetic Field Thoery

  1. A (75 - j 40) W load is connected to a co-axial line of z0 = 75ω at 6 MHz. The load matching on the line can be accomplished by connecting

  2. A.
    a short circuit stub at the load
    B.
    an inductance at the load
    C.
    a short circuit stub at a specific distance from the load
    D.
    a capacitance at a specific distance from the load

  3. A plane wave is characterized by the wave is

  4. A.
    linearly polarized
    B.
    circularly polarized
    C.
    elliptically polarized
    D.
    unpolarized

  5. The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε0. The surface charge density on the conductor is ((ε0 = 10-9/36p)F/m)

  6. A.
    0 c/m2
    B.
    2 c/m2
    C.
    1.8 x 10-11 c/m2
    D.
    1.14 x 10-9 c/m2

  7. A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.

  8. A.
    3 x 108 m/sec
    B.
    5 x 108 m/sec
    C.
    1.5 x 108 m/sec
    D.
    9 x 108 m/sec

  9. A plane electromagnetic wave travels in dielectric medium of relative permittivity 9. Relative to free space, the velocity of propagation in the dielectric is

  10. A.
    increased by a factor of 9
    B.
    increased by a factor of 3
    C.
    unchanged
    D.
    reduced by a factor of 1/3

  11. Consider a loss less antenna with a directive gain of + 6 dB. If 1 mW of power is fed to it the total power radiated by the antenna will be

  12. A.
    4 mW
    B.
    1 mW
    C.
    7 mW
    D.
    1/4 mW

  13. A uniform plane wave is one in which

  14. A.
    x = 0
    B.
    .
    C.
    and are perpendicular
    D.
    and lie in a plane

  15. The electric field of the incident wave is , where ω = 3 x 109p and β = 10 p. The electric field of the transmitted wave Et is given by


  16. A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z0 = 500 ohms, the admittance y seen at the function of the stub and the transmission line is

  17. A.
    (0.01 - j 0.02) mho
    B.
    (0.02 - j 0.01) mho
    C.
    (0.04 - j 0.02) mho
    D.
    (0.02 + j 0) mho

  18. Which of the following should dominant wave have?

  19. A.
    Lowest cut off frequency
    B.
    Highest cut off frequency
    C.
    No attenuation
    D.
    No phase shift