Home / CSE / Computer Hardware :: Section 6

CSE :: Computer Hardware

  1. Which best describes a fragmented hard drive:

  2. A.
    The platters are bad
    B.
    Data files are corrupted
    C.
    Clusters of data are damaged
    D.
    Files are not stored in consecutive clusters
    E.
    None of the above

  3. What resistance in ohms should be displayed when testing a speaker in a computer?

  4. A.
    Q Ohms
    B.
    16 Ohms
    C.
    -200 Ohms
    D.
    Unlimited Ohms
    E.
    None of the above

  5. After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:

  6. A.
    System's floppy drive device driver
    B.
    Original IDE controller
    C.
    Floppy drive ribbon cable
    D.
    System's power supply
    E.
    None of the above

  7. What is the best ground for a conductive work bench?

  8. A.
    AC outlet
    B.
    Ground to bench
    C.
    To the motherboard
    D.
    To the PC's Chassis
    E.
    None of the above

  9. When you are testing a fuse, you should set the Volt-OHM meter to what scale?

  10. A.
    AC
    B.
    DC
    C.
    AMPS
    D.
    OHMS
    E.
    None of the above

  11. During boot-up, the memory test:

  12. A.
    Is a superfluous step that should be ignored
    B.
    Checks and verifies that contiguous memory is installed
    C.
    Is an operational error
    D.
    Displays what memory is installed, but nothing else
    E.
    None of the above

  13. A customer has just installed a new cd-rw. the system was working fine before the installation, but now the cdrom does not work, what should you suggest that the customer do?

  14. A.
    flash or upgrade the BIOS
    B.
    check the CONFIG.SYS
    C.
    add cdrw in the device manager
    D.
    check the jumper setting on the cd-rw
    E.
    None of the above

  15. Which is the most difficult environmentally to dispose of?

  16. A.
    floppy drives
    B.
    hard drives
    C.
    power supplies
    D.
    CRTs
    E.
    system boards

  17. Resistance is measured:

  18. A.
    in parallel
    B.
    in series
    C.
    after breaking the circuit
    D.
    after checking voltage
    E.
    after checking current

  19. Which is LEAST likely to interfere with upgrading to a newer DOS Version?

  20. A.
    ROM BIOS
    B.
    Video controller
    C.
    Compressed drives
    D.
    Existing backup files
    E.
    None of the above