Chemical Engineering :: Process Equipment and Plant Design
-
__________ of water makes it a widely used coolant in heat exchangers.
-
The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)
-
Fouling factor must be included in the calculation of over all design heat transfer coefficient, when the liquid
-
Lug support is meant for supporting __________ vessels.
-
Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.
-
Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate ?
-
In case of 1.5" heat exchanger tubes, the inside flow area __________ with decrease in BWG.
-
Cylindrical pressure vessels in horizontal condition is generally supported on a __________ support.
-
Pressure drop per tray in the atmospheric distillation column is about __________ psi.
-
Welded joint efficiency in the design of chemical process equipment is taken as
Whatsapp
Facebook
