Home / Chemical Engineering / Chemical Engineering Basics :: Section 23

Chemical Engineering :: Chemical Engineering Basics

  1. Hot working of lead is carried out at

  2. A.
    75°C
    B.
    373°K
    C.
    150°C
    D.
    room temperature

  3. An engineer's hammer is made of high __________ steel.

  4. A.
    carbon
    B.
    speed
    C.
    silicon
    D.
    chromium

  5. Impeller & casing of centrifugal pump handling corrosive liquid and frequently running under cavitation condition is most prone to __________ corrosion.

  6. A.
    uniform
    B.
    oxygen diffusion
    C.
    pitting
    D.
    inter-granular

  7. Isotropic materials have the same __________ in all the directions.

  8. A.
    thermal properties
    B.
    elastic properties
    C.
    stresses
    D.
    all (a), (b) & (c)

  9. The gases used in the treatment of asthma is a mixture of __________ and oxygen.

  10. A.
    helium
    B.
    argon
    C.
    neon
    D.
    none of these

  11. Grinding wheel made of silicon carbide is most suitable for grinding materials of low tensile strength (e.g; tough bronze). Grinding is a __________ operation.

  12. A.
    turning
    B.
    dressing
    C.
    forming
    D.
    surface finishing

  13. Which of the following is the most effective inhibitor of grain growth, when added in small quantity in steel ?

  14. A.
    Manganese
    B.
    Vanadium
    C.
    Cobalt
    D.
    Copper

  15. A controller action in which there is a con-tinous relation between the values of controlled variable and the rate of change of conrolled output signal is called the __________ action.

  16. A.
    proportional
    B.
    integral
    C.
    derivative
    D.
    none of these

  17. An ideal fluid is

  18. A.
    viscous & incompressible.
    B.
    non-viscous & compressible.
    C.
    non-viscous & incompressible.
    D.
    viscous & compressible.

  19. When dry bulb temperature & wet bulb temperature of moist air is the same, it means that the

  20. A.
    partial pressure of water vapour is less than the total pressure.
    B.
    humidity is < 100% & dew point temperature of air has not reached.
    C.
    dew point temperature of air has not reached & air is not saturated fully.
    D.
    air is fully saturated.