Home / Chemical Engineering / Chemical Engineering Basics-2 :: Section-1

Chemical Engineering :: Chemical Engineering Basics-2

  1. Out of the following, which will fracture most readity, when hit with a hard hammer ?

  2. A.

     Brass

    B.

     Bronze

    C.

     German silver

    D.

     Cast iron


  3. Dezincification is a form of corrosion, which specifically applies to

  4. A.

     Steel

    B.

     Brass

    C.

     Stainless steel

    D.

     Babbit metal


  5. Oxyacetylene reducing flame is used while carrying out welding on

  6. A.

     Alloy steel

    B.

     Grey cast iron

    C.

     Mild steel

    D.

     High carbon steel


  7. Oxyacetylene reducing flame is used while carrying out welding on

  8. A.

     Alloy steel

    B.

     Grey cast iron

    C.

     Mild steel

    D.

     High carbon steel


  9. If the head is doubled in & centrifugal pump, the power required will increase in the ratio of

  10. A.

     23

    B.

     23/2

    C.

     25/2

    D.

     21/3


  11. Two wires of the same radius & material having length in the ratio of 1 : 2 are stretched by the same force. The strain produced in the two wires will be in the ratio of

  12. A.

     1:1

    B.

     1:2

    C.

     2:1

    D.

     1:4


  13. __________ of air does not increase with increase in temperature.

  14. A.

     Density

    B.

     Thermal diffusivity

    C.

     Viscosity

    D.

     Thermal conductivity


  15. Nusselt number is related to the Reynolds number (Re) in turbulent & laminar flow respectively as

  16. A.

     Re0.5, Re0.8

    B.

     Re0.8, Re-0.5

    C.

     Re0.8, Re0.5

    D.

     Re-0.8, Re0.5


  17. Oxygen cylinders used for autogenous (cutting/welding) purposes are

  18. A.

     Seamless & made of steel

    B.

     Heat treated before use

    C.

     Made by sand casting

    D.

     Welded steel cylinders


  19. To improve the machinability of steel, it is generally subjected to

  20. A.

     Spherodising

    B.

     Tempering

    C.

     Normalising

    D.

     Annealing