Home / Mechanical Engineering / Hydraulics and Fluid Mechanics in ME :: section-1

Mechanical Engineering :: Hydraulics and Fluid Mechanics in ME

  1. Which of the following statement is wrong?

  2. A.

     A flow whose streamline is represented by a curve is called two dimensional flow.

    B.

     The total energy of a liquid particle is the sum of potential energy, kinetic energy and pressure energy.

    C.

     The length of divergent portion in a Venturimeter is equal to the convergent portion.

    D.

     A pitot tube is used to measure the velocity of flow at the required point in a pipe.


  3. Which of the following statement is wrong?

  4. A.

     The reaction turbines are used for low head and high discharge

    B.

     The angle of taper on draft tube is less than 8°

    C.

     An impulse turbine is generally fitted slightly above the tail race

    D.

     A Francis turbine is an impulse turbine


  5. An open vessel of water is accelerated up an inclined plane. The free water surface will

  6. A.

     Be horizontal

    B.

     Make an angle in direction of inclination of inclined plane

    C.

     Make an angle in opposite direction to inclination of inclined plane

    D.

     Any one of above is possible


  7. Newton's law of viscosity is a relationship between

  8. A.

     Pressure, velocity and temperature

    B.

     Shear stress and rate of shear strain

    C.

     Shear stress and velocity

    D.

     Rate of shear strain and temperature


  9. The rise of liquid along the walls of a revolving cylinder about the initial level is _________ the depression of the liquid at the axis of rotation.

  10. A.

     Same as

    B.

     Less than

    C.

     More than

    D.

     None of these


  11. Mercury is often used in barometer because

  12. A.

     It is the best liquid

    B.

     The height of barometer will be less

    C.

     Its vapour pressure is so low that it may be neglected

    D.

     Both (B) and (C)


  13. A compound pipe is required to be replaced by a new pipe. The two pipes are said to be equivalent, if

  14. A.

     Length of both the pipes is same

    B.

     Diameter of both the pipes is same

    C.

     Loss of head and discharge of both the pipes is same

    D.

     Loss of head and velocity of flow in both the pipes is same


  15. For a floating body to be in equilibrium

  16. A.

     Meta centre should be above e.g.

    B.

     Centre of buoyancy and e.g. must lie on same vertical plane

    C.

     A righting couple should be formed

    D.

     All of the above


  17. The specific speed of a hydraulic turbine depends upon

  18. A.

     Speed and power developed

    B.

     Discharge and power developed

    C.

     Speed and head of water

    D.

     Speed, power developed and head of water


  19. The runaway speed of a hydraulic turbine is the speed

  20. A.

     At full load

    B.

     At which there will be no damage to the runner

    C.

     Corresponding to maximum overload permissible

    D.

     At which the turbine will run freely without load